Options

Options/Bufferstart

The data to be programmed can be found starting at this buffer address.

Options/Bufferend

Data will be programmed up to this buffer address.

Options/Epromstart

Data will be programmed or read starting at this device address. The first byte on the buffer start address will be programmed to this address, all further bytes up to the buffer end address follow in an ascending order.

Options/Fileoffset

With File/File load all data up to this address will be ignored. With files with a absolute address (HEX- or S-files) the offset address will be subtracted from the internal address. The address area of such files will thus be lowered by the offset address before loading into the buffer.

Options/Data capacity

The data capacity of the target system's bus. If the data capacity given here exceeds that of the device to be programmed, the data will be distributed among more than one device during programming.

Options/Programming-Mode

Special modes and bits depending on the device to be programmed (GAL, EEPROM/Flash-EPROM or Microcontroller).