The Adapter GALAD44-1

GALAD44-1

Art.-No. 210 841

GALAD44-1 adaptable devices

There are obviously different ways to allocate pin numbers between two case designs - especially if one of the cases has four pins more than the other. In the market-place, two ways of allocating pins are now predominant (c.f. table). The type 1 allocations can usually be found with memory devices. The type 2 allocation on the other hand is with 83/87x51 type microcontrollers.

Selecting one type is effective through the plug-in jumpers J1 and J2.

Unfortunately there are still a few devices with pin allocations that do not comply with either of those types. They can not be programmed with the GALEP adapter.

Allocation of pins DIL connection of the adapter on PLCC base

J1=1-2 / J2=1-2: Type 1

J1=2-3 / J2=2-3: Type 2

Before inserting the device do check which of the two types of allocation is valid and whether the jumper was plugged in accordingly.

See also Using adapters in Galep-4