PIC16C923, PIC16C924, PIC16C925, PIC16C926, PIC16LC923, PIC16LC924, PIC16LC925 and PIC16LC926 are offered in PLCC68-, CLCC68-, TQFP64- and SPDIP64-packages. They do not fit into the 48/40-Pin-DIL-socket of GALEP-5/-4/-3.
CONITEC does not offer a special adaptor for these devices so it is up to you to build your own one..
That's what you need:
1.: 40-Pin-DIL-socket,
2.: about 25cm (10 inch) Wire,
3.: Programming-socket ready to accept the device.
4.: appropriate tools
The following connections are necessary for programming these devices:
| Signal | GALEP-5-Pin | GALEP-4/3-Pin | PLCC68-Pin | CLCC68-Pin | TQFP64-Pin | SDIP64-Pin |
| RB6 | 43 | 39 | 65 | 65 | 53 | 61 |
| RB7 | 44 | 40 | 66 | 66 | 54 | 62 |
| /MCLR | 5 | 1 | 2 | 2 | 57 | 1 |
| VDD | 15 | 11 | 22 | 22 | 12 | 20 |
| VDD | 36 | 32 | 64 | 64 | 52 | 60 |
| VSS | 16 | 12 | 23 | 23 | 13 | 6 |
| VSS | 35 | 31 | 7 | 7 | 62 | 21 |
PLEASE NOTE: The information given cannot be covered by a warranty.
Please always check the position of the pins mentioned using the device's documentation.
We can not offer any warranty covering damage to Galep or the device caused by faulty wiring.